ZOLL M Series Defibrillator Battery Interconnect Board Assembly For Units EtC02 9301-0303

► Specification

► Detailed Photos

► Remove

Required Tools:Orange stick

Setup

1. Remove the front panel assembly.

2. Remove the upper housing assembly

3. Remove the System Board Battery Cable.

Step 1: Identify the Battery Interconnect Board.

Step 2: Remove the wide laminated cable from the high voltage module connector by lifting the cable vertically.

Step 3: Remove the thumbtack and small insert ring.

Step 4: Rotate the device so that the rear of the device is facing you. Rotate the battery interconnect board up toward the front of the device.

While holding the board vertically, remove the 10-pin laminated cable from the connector by lifting the connector lock.

NOTE

• For step 4, when removing and reinstalling the charger assembly, remember to carefully remove the cables from the charger assembly.
• To reinstall the battery interconnect board, follow these steps in reverse order.

► More Details

Here's what the ZOLL Battery Interconnect Board 9301-0303 does:

1. Realize the connection between the battery and the defibrillator: ensure that the power of the battery can be stably and effectively transmitted to each working part of the defibrillator to provide power support for the normal operation of the defibrillator.

2. Manage the charging and discharging process of the battery: monitor and control the charging state of the battery to prevent overcharge or overdischarge to extend the service life of the battery.

3. Ensure the stability and security of the circuit: by optimizing the circuit design and using high-quality electronic components, reduce the resistance and interference in the circuit, and ensure the stability of current transmission.