FUKUDA CardiMAX FX-7202 ECG Machine Program Cartridge PC-7403 In Good Working Hospital Devices

FUKUDA CardiMAX FX-7202 ECG Machine Program Cartridge PC-7403 Used in Good Working Hospital Devices

► Brief Introduction

Some of the functions are available only when the program cartridge is installed. The operation of the FX-7202 varies depending on the installed program cartridge.

• If you do not use the FX-7202 for an extended period of time, remove the battery from the unit. Even if you do not use the FX-7202, use the unit to fully charge the battery at least once every three months. If you do not charge the battery, it will automatically discharge and you may not be able to use it again.
• Do not use the battery in places where the room temperature is below 0 degrees Celsius (32 degrees Fahrenheit) or above 40 degrees Celsius (104 degrees Fahrenheit).
• Charge the battery at room temperature between 10 and 30 degrees Celsius (50 and 86 degrees Fahrenheit).
• Store the battery at room temperature between 0 and 30 degrees Celsius (32 and 86 degrees Fahrenheit).
• Repeated short discharge and charge cycles will cause the battery to no longer operate at full capacity. Before charging, make sure the battery is completely depleted.
• If the battery is depleted, you should charge it even if you are not going to use it right away. If you do not charge the battery, it will automatically discharge and you may not be able to use it again.
• Battery life varies depending on operating conditions. Normally, the battery is replaced after 300 charge/discharge cycles. When the battery is nearing the end of its life, its capacity will be significantly reduced. In this case, please replace it with a new battery.

► Specifications

► Before attaching the electrodes to a patient

Check the patient's condition

Check the patient's condition and see if they are quietly and comfortably resting. If the patient is tense, talk to them to relieve tension. For example, ask them to "relax your arms and legs and relax completely" or "breathe normally." If the patient's arms or legs are tense or if the patient is constantly moving, an accurate ECG cannot be recorded. This will cause problems such as ECG interference and baseline instability.

Clean skin

Use a cloth moistened with alcohol to wipe the parts of the patient's body where the electrodes will be attached to remove any dirt or oil. Any foreign material left on the skin or electrodes will increase the contact resistance and cause unstable recordings.

Apply keratin cream

Apply keratin cream to improve contact between the skin and the electrodes. Rub the cream into the patient's skin until the skin is slightly reddened. When applying cream to different areas of the chest to connect the electrodes, make sure the cream on these different areas does not overlap or touch. If too much keratin cream is applied and adjacent electrode sites on the chest are connected, an accurate ECG will not be recorded.

The configuration of the Cardimax FX-7202 depends on whether the optional program cartridge PC-7403 is installed.

After installing the PC-7403 program cartridge, you can perform optional functions of the Cardimax FX-7202. The following table summarizes the functions available with and without PC-7403

Before using the Cardimax FX-7202, determine its configuration and find the supported features from the table above.

Thank you for your time and interest. All through the way we seek for providing perfect service to the satisfaction of customers. If you are interested in FUKUDA CardiMAX FX-7202 ECG Machine Program Cartridge PC-7403 Used in Good Working Hospital Devices, welcome to place your orders.